Transition Networks Point System RS232 Copper to Fiber Media Converter

Transition Networks' serial RS232 to Fiber Media Converter allows you to extend the distance between serial connections with the use of fiber optic cable. This full-featured converter transmits the full complement of RS232 flow control/handshaking signals optically and supports full or half-duplex asynchronous data transmission at speeds up to 115Kb/s.

The diagnostic features included on this converter make installation easy and intuitive. A DTE/DCE switch eliminates the frustration over selecting the appropriate cable. A loop-back switch allows for complete diagnostic testing prior to system turn-up or during troubleshooting. Unit and Port LEDs allow for quick status information of the converter.

Switches:

• DTE/DCE
• Loop-back
• Loopback (Local or Remote on copper and fiber)

Supports the following flow control signaling:

• DCD - Data Carrier Detect
• RXD - Receive Data
• TXD - Transmit Data
• DTR - Data Terminal Ready
• SG - Signal Ground
• DSR - Data Set Ready
• RTS - Request To Send
• CTS - Clear To Send

Pointy System Chassis

• EIA/TIA-574
• EIA/TIA RS-232E

Compliance:

• CISPR22/EN55022 Class A + EN55024
• EN60950 Class A
• FCC Class A
• CE Mark